Hi there all at91sam7x developers,
we have really big problems running the rl-arm library (MDK-ARM RealView Microcontroller Kit 4_01) since we need to make use of the sysirq of the at91sam7x512 device which is not only used by the PIT we use for the scheduler timer tick but shared with other chip components like DBGU, RSTC, RTT, WDT and PMC.
We cannot change to the three other timers (TCx) because we use them already for other pupose.
In the default setting of edge mode the RTT cannot work properly and end up in a froozen scheduler and a always running idle task after 10-25 minutes (google retrieves other threads describing this similar).
We changed the OS_TINIT macro (in RTX_Config.c) to set the level mode for the sys irq (AIC->AIC_SMR[ID_TC] = (AT91C_AIC_SRCTYPE_INT_HIGH_LEVEL| AT91C_AIC_PRIOR_HIGHEST)) as everyone in the web suggests (google told us) and we noticed the macro AT91C_TFIRQ to trigger the clock interrupt by software cannot work anymore because the AIC does not support software triggering of irqs in level mode.
At the moment I'm trying to change temporary back to edge mode of the AT91C_TFIRQ macro to make software triggering of the irq working again for it and keep my fingers crossed this will work stable for hours:
#define AT91C_TFIRQ AT91C_LOCK; AIC->AIC_SMR[ID_TC] = (AT91C_AIC_SRCTYPE_INT_POSITIVE_EDGE| AT91C_AIC_PRIOR_HIGHEST); \ AT91C_UNLOCK; \ AIC->AIC_ISCR = OS_TIM_; \ AT91C_LOCK; AIC->AIC_SMR[ID_TC] = AT91C_AIC_SYSSRCTYPE; AT91C_UNLOCK
In level mode it works properly as soon as the load of os_xxx calls is very low. Having the full application running the system runs like the idle task runs (but others still run as breakpoints shows) only after about 1 hour. Things like os_sem_wait calls doesn't respond at os_sem_send calls happen and much more...
We have a mean stack loading of our 24 tasks of 50% max each.
Anyone experienced by using the sys irq of the at91sam7x in combination of the RL-ARM library driven by the PIT (not any TCx) out there?
Please help me!!
Best regards Helmut
I use the sys irq in level mode so I cannot miss any irq. I do this for all irqs.
Unfurtunality rl-arm's rtx_config.c sets the edge mode but works.
When you use other peripherals that share this sys irq you need (before you may have edge too) to change to level mode (especially for the asyncronously to mck fired rtt). This level works fine but rl-arms scheduler requires triggering by a simple software command of the scheduler for additional runs.
When this additional runs of the rl-arm scheduler are not happen too long internal queues seems to overflow (what is just ignored in rl-arm as much I can see in the source) and this will end to lost messages and for internal queues lost commands (done for any isr_xxx calls of rl_arm like isr_mbx_send etc.)
Thanks for you valuable input. Go on and kick my brain to the right point;-)