This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RTX : EX1 doesn't run using LPC2368

I have tested Keils RTX Program EX1.c using Lpc2124 using the Debugger and everthing ran OK.

So I modifed the EX1.c Prog for the LPC 2368.
1) Used LPC23xx.h through-out.
2) Removed Startup.s and used lpc2300.s and modifies the SWI Handler
as described by Keil.
3) set T1TCR to 0 before os_init.

Started the Debugger and displayed OS-Support-> rtx-kernel it shows:
task 1 wait_or " " 0000 0004 36% (ie no delay is shown, wait for event)
task 2 wait_delay 2 " " " " 32% (ie no events expected)
idle_os_demon 0%

There is no task switching going on.

Looking at Clock dividers the CCLK regularly changes from 48 to 2 MHz
and back again...and this appears to me ti be wrong, but cannot find out why. I have a suspicion that the reset handler is being called.

I'm using the Keil Demo V4 uVision on Win XP.

Can any one help me out to locate the problem?

Bonzadog

Parents
  • If the EMC is enabled the startup hangs up - I found that out and set EMC from equ 1 to equ 0 in lpc23xx.s .Thanks anyway.

    The problem has now been solved :

    The startup ,l pc23cc.s , was OK

    But in RTX_Config.c under

    #define OS_TINIT() VICVectAddr115 = (U32)os_clock_interrupt; \
    was originally set and so I changed it to VICVectAddr5 = (U32)os_clock_interrupt; \
    and the timer now gets the required interrupt vector.
    and the tasks are now switching.

    But I'll be taking a closer look at this, though.

    Many thanks

Reply
  • If the EMC is enabled the startup hangs up - I found that out and set EMC from equ 1 to equ 0 in lpc23xx.s .Thanks anyway.

    The problem has now been solved :

    The startup ,l pc23cc.s , was OK

    But in RTX_Config.c under

    #define OS_TINIT() VICVectAddr115 = (U32)os_clock_interrupt; \
    was originally set and so I changed it to VICVectAddr5 = (U32)os_clock_interrupt; \
    and the timer now gets the required interrupt vector.
    and the tasks are now switching.

    But I'll be taking a closer look at this, though.

    Many thanks

Children
No data