We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hello,
Here is an message I have sent to Keil support - please let me know if it applies to you too.
"Hello,
We have a big problem with the latest MDK that upgraded the firmware on our ULINK 2 devices. Ever since, every time we click the "settings" button on the "options for target->debug" page, our target device (LPC2478) resets (whether the debugger runs or not). I have noticed this immediately after the installation, and it gets even worse: removing a breakpoint during a debug session can also reset the target! this makes the debugger almost useless under certain conditions. Are you aware of this issue or is this a hardware problem we have? note: we was not a problem with older MDKs/ULINK 2 firmware."