Hi,
I am using the ethernet interface of MCBSTR9 to comminicate. I used the code to initialize the enet and phy chip, and also to send and recv data in the http demo at "http://www.keil.com/download/docs/318.asp". And I am trying to test my code by sending periodic data(~=100 bytes average) from a PC. When the sending frequency is greater then 100 milisecond it looks ok, however when I set sending frequency below 100 milisecond the ethernet interface stops the sending and recving after a few minutes. Could you give me some suggestions?
Thank you.
Use the Debugger to determine where, exactly, it is "stopping".
That should give you some clues to trace back to the cause...