This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Displays Content Mismatch after loading

Hi,

We are using Uvision4 for AT91SAM7L128-IC

AT91SAM7L-STK---- eval Kit
When we have created the new sample application and try to laod the code it is showing
Content Mismatch at 0x100000H(Flash=FFH: Required=00H)
We have commented the verification after download and started debugging, The program is not executing the main function

Thank You
Harish G

Parents

0 cheng bei over 15 years ago

I just use the AT91SAm7S64 one month. I found that we had to erase the flash in the IC before to download the .BIN file into the IC using the SAM-BA V2.7
Cancel
Vote up 0 Vote down

Cancel

Reply

0 cheng bei over 15 years ago

I just use the AT91SAm7S64 one month. I found that we had to erase the flash in the IC before to download the .BIN file into the IC using the SAM-BA V2.7
Cancel
Vote up 0 Vote down

Cancel

Children

0 Hi Harish G over 15 years ago in reply to cheng bei

Hi,

Thanks for you reply ..

We are erasing the flash and then loading the hex file.
Cancel
Vote up 0 Vote down

Cancel