We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi all,
I'm using 89C52 controller in my application. I'm using a 90 byte buffer to store received message from UART. Based on this received message I'm controlling I/O ports. The same buffer I'm using for transmitting the application dependent internal status message.
To identify the message I'm using absolute address position for example, if(arr[59] == '*'){do something;}
every first message after reset this is working fine. After that the control hangs somewhere thus its giving undetermined behavior.
I set the memory model as Large: all variables in XDATA.
I hope some address overflow is happening here.
Can anyone help me to resolve this issue.
Thanks in Advance.
Regards, Ramesh
re-post using the proper tags please!
Here is the code again..
#include<serial.h> #include <AT89X52.H>
unsigned char message[35]; unsigned char Request[35];
main() { unsigned char i,j;
// UART functionlity working fine with 9600 baud
Init_Uart(); while(1) { for(i=0;i<=35;i++)
{
//Rx buffer for first 35 char's // controll waits here for incoming char
message[i]=RX_CHAR(); process=1;
}
if(process==1)
// I'm sure that this characters are 26th // character always from transmitter
if(message[25]=='*')
pass =1; TestLED=ON;
else if(message[25]=='#')
pass =0; TestLED=OFF;
process =0;
if(pass==1)
for(j=0;j<=35;j++)
Request[j]= 'A';
// Request array is transmitted Note this // subroutine is tested working correctly.
Send_Str(Request); }
else if( pass==0)
Request[j]= 'B';
Send_Str(Request);
} } }
Thanks
unsigned char message[35]; unsigned char Request[35]; for(i=0;i<=35;i++) { //Rx buffer for first 35 char's // controll waits here for incoming char message[i]=RX_CHAR(); process=1; } for(j=0;j<=35;j++) { Request[j]= 'A'; }
YOU ARE FILLIN G A 35 CHARACTER ARRAY WIT H36 CHARACTERS!
THAT IS OVERFLOW!
narak, don't you think it is only appropriate to also SCREAM in the code that you post?!
<QUOTE>don't you think it is only appropriate to also SCREAM in the code that you post?!</QUOTE>
HE DOES NOT WANT TO LISTEN TO MY ANSWER WHO I THINK IS CORRE CT!
IS HE DEF?
the OP probably already implemented your careful advise. there is no need to use UPPERCASE. that won't make his listen - just annoy everyone else.
Hi Narak,
I had already modified the code as below. But still its not working.
for(i=0;i<=34;i++) { message[i]=RX_CHAR();
I'm using Uvision3 IDE version 3.30a. I have not tried out with older version of IDE. Will it cause any problem??