Hello can someone tell me why my interrupt does not respond, with the debugger, I always get z = 0
double z; main { . . . . . . while(1) { CC1_M2 = 0x0001;// 001=>capture on posirtive Flanke CC1_T01CON = 0x0047; CC1_CC8IC = 0x00C0; // Interrupt enable und z = Periode ; }//end of while }// end of main void Drehzahl_messung(void) interrupt(0x18) { Periode = 100; }
or what I have since forgotten Thanks
It works because reading the 16-bit value of Timer_Diff is atomic by the processor design. If you had a 32-bit value which you modify in the interrupt and read in the main loop, that would most certainly not work as it does now.