Just started a project to build a robotic arm.
I am using an 80c410 with the processor conected to the attenuators and sensers and i have a lot of flash for code.
I am use using Alumineum for the arms and leg. It's OK cutting the stuff, it's just shaping it that is a bit of a task. Files soon get clogged up and a grinder is just as bad. I was think of using my woodwork router to get the shapes that I want. As anyone done this or do you know the best tools to work with Aluminium.
Cheers' Tom
I'm sure that this information must be in the Bible everyone keeps talking about around here.
there is ALU minimum :)
Erik
In no particular order:
http://www.keil.com/forum/docs/thread12851.asp
http://www.keil.com/forum/docs/thread12832.asp