Keil forum Can I debug a HEX file use uVision debugger?

State Not Answered
Locked Locked
Replies 4 replies
Subscribers 22 subscribers
Views 1949 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can I debug a HEX file use uVision debugger?

li ruiming over 17 years ago

Hi,

I want use uVision debugger to single step a HEX file, which use LPC2220. How do I do?

Thanks a lot,
li ruiming

Parents

0 ImPer Westermark over 17 years ago

Note that the hex file will not contain any debug information. Single-stepping assembler instructions without correlation to any source or any comments is not fun.

So, why do you want to debug the contents of a hex file?
Cancel
Vote up 0 Vote down

Cancel

Reply

0 ImPer Westermark over 17 years ago

Note that the hex file will not contain any debug information. Single-stepping assembler instructions without correlation to any source or any comments is not fun.

So, why do you want to debug the contents of a hex file?
Cancel
Vote up 0 Vote down

Cancel

Children

No data