This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

rs232

I would like to program an 8051 development board using Keil and was wondering if it was at all possible to send a hex file (flash the ucontroller) via the rs232 serial com port. Could anyone tell me the options for doing this? Thanks

Parents

0 lordy r over 17 years ago in reply to erik malund

Thanks Erik

What software do you use to download the hex file onto the NXP chips. I believe FLIP doesn't support these chips.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 lordy r over 17 years ago in reply to erik malund

Thanks Erik

What software do you use to download the hex file onto the NXP chips. I believe FLIP doesn't support these chips.
Cancel
Vote up 0 Vote down

Cancel

Children

0 erik malund over 17 years ago in reply to lordy r

free from http://www.esacademy.com (and paid for by NXP)

Erik
Cancel
Vote up 0 Vote down

Cancel