This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SCON0 is not being set when I use the Debugger

I am using the KEIL IDE for developing a Silicon Labs C8051F125. I am using the debugger to debug the setup of UART0. I am watching the value in SCON0 and TMOD and even though I can step though the code and see it setting SCON0 to 0x50 the watch does not show the updated value.

I would like to know if I missed anything in the setup of the debugger?

Parents Reply Children