• State Not Answered
  • Locked Locked
  • Replies 8 replies
  • Subscribers 22 subscribers
  • Views 2264 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

CLOCK TOO SLOW AND MUST BE FASTER

jchoo235

I NEED THE PORCESSOR TO RUN AT 82MHZ BUT THE XTAL IS 13>7242MHZ

HOW DO I PROGRAM C TO GET THE CODE FASTER?

I LOOK IN UVISION AND CHANGE THE FREQ BUT IT DOESNT MAKE CHANGE IN CODE! HAVE I GOT A BUG?

Parents
  • 0 in reply to jchoo235

    can handle 82MHz is the SILabs f12x/f13x. so that must be the one you use. look at PLL0MUl.

    I LOOK IN UVISION AND CHANGE THE FREQ BUT IT DOESNT MAKE CHANGE IN CODE! HAVE I GOT A BUG?
    a) if you conmtinue SHOUTING, this will be my last post to you, if the caps lock key is stuck, get a new keyboard.
    uVision does not do diddlysquat when you cnahnge the frequence, that is a code issue i.e. it is YOUR job.

    Erik

Reply
  • 0 in reply to jchoo235

    can handle 82MHz is the SILabs f12x/f13x. so that must be the one you use. look at PLL0MUl.

    I LOOK IN UVISION AND CHANGE THE FREQ BUT IT DOESNT MAKE CHANGE IN CODE! HAVE I GOT A BUG?
    a) if you conmtinue SHOUTING, this will be my last post to you, if the caps lock key is stuck, get a new keyboard.
    uVision does not do diddlysquat when you cnahnge the frequence, that is a code issue i.e. it is YOUR job.

    Erik

Children
No data