We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hello I am getting very serious problem, The code written for phillips 89V51RD2 , after some days the code written in keil will not work on the same hardware .If i write same code once again without copy/paste it will work . Please any body have solution for this.
Regards Santosh Hegde.
I HAD SAME PERBLOM BUT SET IG BIT OF SCIN REGISTER
"I HAD SAME PERBLOM BUT SET IG BIT OF SCIN REGISTER"
Why did you choose to write that in ALL CAPITALS? Writing in ALL CAPITALS just makes the text harder to read, and is considered to be SHOUTING - hence rude! Please don't do it!
Are you saying that setting "IG bit of SCIN" seemed to cause your problem, or cure it?
Sorry for SHOUTING. I didnt notice my caps lock was on.
As i said I try IG bit of SCIN.
Sorry I didnot answer youre question fully.
Before I tried controlling LCD with PM bit of SMAP and RL bit of GMAP but this donot work :(
I try IG bit of SCIN and it did work :)
"I didnt notice my caps lock was on."
You didn't pay attention to the Preview of your post, then?
"...with PM bit of SMAP and RL bit of GMAP but this donot work; I try IG bit of SCIN and it did work"
So how does this relate to the rest of this thread, where the same code apparently sometimes works and sometimes doesn't?
weeeeeeep
I feel soooooo stupid ------- NOT
bcoz I had the same problem where the code sometimes did work and sometimes does not!
Also the PSU sometimes had excessive ripple
And youre suggestion is?
and there was a glitch that made the code to twarp off into the erase routiones
I didnt notice my caps lock was on.
you must be the first blind participant in this forum.
Erik
Don't cry over spilled milk.