Hi.
Does the Keil uLink allow me to download a binary (bin or hex) file into the internal flash of the STR710FZ2(H6) target? The download must be remotely controlled (say, from LabVIEW), so I basically need a command line interface to erase, program, verify, blank check, read target ID etc. This cmd interface can be exe or dll-based for my needs, but a GUI is not an option as there will not be an operator to interact with the download process.
We're talking an automated production/test station that'll start out by downloading a bootstrap into the STR710FZ2H6 via its JTAG port. The bootstrap is currently available, so I do not need any debuggers, emulators, compilers etc. - just a way to download my file into the target in an automated environment.
Do you have any OTS products that I can use for this?
Best regards Steen, Denmark
Your limits would more come from what you can do with a project than with the -f
You can make a project that will just erase the flase (sector or full erase) (look under Flash Download Setup in uvision)
You can make a Seperate prject to do something else. (i.e. burn an image but not erase the flash)