I am trying out two boards for a wireless app, the Chipcon cc2510, and the Nordic nRF24E1, both have 8051 on board. They are each geared towards one IDE or another, Nordic and Keil, Chipcon and IAR.
Anyways, I am having trouble right now adding ANY lines to my code. I dont get a compiler error, but do get an error when programming the EEPROM (using a dev kit). I do NOT get an error when "emulating" the EEPROM with the supplier dongle. Code=922, data=54. Any ideas? I get and error when programming the onboard EEPROM that there was an error programming. Any thoughts? Thanks.
"get an error when programming the EEPROM ...
What does that have to do with Keil?
I know of no Keil 'feature' to load code memory with the program.
Erik
"I know of no Keil 'feature' to load code memory with the program."
Ah - but you don't use the IDE, do you?
uVision does support downloaders - including FlashMagic, and others like the various JTAG thingies available...
However, the actual downloader is a 3rd-party tool - uVision merely provides an interface to it.
Therefore any stupid, useless messages like "There was an error programming the EEPROM" are the fault of the 3rd-party developer.
[rant] Surely, it must have been a software developer who coded that message - don't they know from experience just how useless such a message is?! [/rant]
a) "I know of no Keil 'feature' to load code memory with the program."
b) "However, the actual downloader is a 3rd-party tool - uVision merely provides an interface to it."
I will agree that yours is more explicit.