This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ADUC 842 Off-Chip XDATA

Hi,

We've mounted a 32kB external SRAM on an Eval ADUC 842 board (using U6 and U7 locations). Which configuration should we use in the startup file and SFRs?

Has somebody a working example (with source code) so as to ensure that component are properly soldered? (I've tried today to code a litlle program to test that, allocating and reading a large array, but without success, so I want to isolate hardware and software problem)

Thanks for your answers,

Lionel

0