Hi.I am a student at electrical & electronics engineering.My final project is related to this topic.I have a 8051 board that has a serial communication with computer.I have a software that is written on Keil uVision programme and it works properly.My aim is to use Matlab programme instead of using Keil uVision.I tried several times and I saw that Matlab transmits the data to the 8051 board by using serial port but the board doesn't work in spite of receiving the data.I am waiting for you ideas to solve this problem.Thank you for your attention.Bye:))
I couldn't solve this problem below: warning: a timeout occured before the terminator was reached. i cannot stop my matlab programme.this error occurs all the time than i can only do Ctrl+Alt+Delete to stop it. I think my matlab programme runs but don't see a terminator to stop.So what is terminator and how can i add it to my programme to solve this problem. Do İ have to add a terminator code to the programme in uvision2 that is written by using c programme? When i read the matlab help i saw terminators as CR and LF.What are they and what is the difference between them?How can i add them to my programme? Thank you for your attention!!
Now you're asking Matlab questions - so you need to ask Matlab.