I want to put the code written in assembly file at specific location say 0x5000. Can someone give me procedure with proper example for doing the same code? I have checked using "AREA" directive, but unable to find how to specify the address in it.
"Use the AREA directive to name the section and set its attributes. The attributes are placed after the name, separated by commas." www.keil.com/.../armasm_dom1359731143697.htm www.keil.com/.../armasm_dom1361290002714.htm
So the AREA directive is about naming sections & setting their attributes - not about placing them in memory.
The tool which allocates sections to specific addresses is the Linker...