Support forums

Keil forum Reset UlinkPro Tool via DOS Command Line

State Not Answered
Locked Locked
Replies 1 reply
Subscribers 21 subscribers
Views 1116 views
Users 0 members are here

Options

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Reset UlinkPro Tool via DOS Command Line

Dan Brandt over 8 years ago

Is there a method via a Dos command batch file, to perform a reset of the actual ULINKPRO Module Tool? Having an issue where I have to unplug the Ulink Tool upon a PC reboot.