Can I use uLink2 with STM32F072 Nucleo 64 board?
Snap off the ST-LINK portion of the NUCLEO
Connect
5V to CN7 Pin 6 VTREF to 3.3V SWCLK to CN7 Pin 15 SWDIO to CN7 Pin 13 SWO to CN10 Pin 32 NRST to CN7 Pin 14 GND to GND
Jumper NUCLEO to use E5V
>>SWO to CN10 Pin 32
CN10 pin 32 is AGND. Should it be CN4 pin 6?
Also VTREF is ulink2 pin 1 of 20 pin connector correct?
Connections you have specified works perfectly. Ignore my question on CN10 vs CN4.
Thanks a lot.
Sorry issue transcribing my notes for the User Manual schematic SWO is PB3 on CN10 pin 31