Hello,
I am very new to Keil environment. I am using serial interface to connect to board for the target Dolphin Flip80251 Typhoon. In Debug tab, i use as Driver DLL (S251.DLL) and Dialog DLL (TP51.DLL). After Building my project, the debugger can't start. I have an error "Error: Target DLL has been cancelled - Debugger aborted" I did check to the Silabs Threads. The only clue i have is that something might be wrong when configuring parameters in the "Target" tab. But can't figure out what could be the reasons. I need your help please to understand what is wrong. Thanks
Hi,
Actually board is an internal IP. so i guess i should contact the support or supplier.
For other information, I am using uVision2 Debugger and no specific utilities - i used default for that.
I just Silabs part to see if i could find some hints. I will go through the doc again because in simulation mode, it works
Thanks