1)Unit can be configured with Target Board (ADUCM360) and shows the Target Serial No and we can set the clock frequency. Set to 1MHZ to test Normal 10Mhz
2)Upon load 1st time we are getting Error -Can't access Memory
3)Upon load 2nd time- Can't enter Debug Mode-
Need help to resolve the issue.
See the below link to troubleshoot this error: http://www.keil.com/support/man/docs/ulink2/ulink2_errors.htm
The Error Messages are Generic and not helping to address our issue. Can we please get a specific reply to our issue- is it a Hardware Problem or Firmware problem??
Reset is Pulled Low and causing this issue. Does any one have Schematics of the ulink v5.1 Board and Part list to change the IC. Please let me know
Thanks Krishna.P.N.