• State Accepted Answer
  • Locked Locked
  • Replies 5 replies
  • Subscribers 21 subscribers
  • Views 2919 views
  • Users 0 members are here
2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem while relocating a code with uvision

Aina R

Hello,

I am developping a bootloader for a STM32F407 using Keil uvision 5 as IDE.
My bootloader shall start at the beginning of flash, (0x0800 0000), as in this microcontroller this is where the littlest sector is. As this is the default start address for Keil, I got no problem to flash and run it.

But when I try to re-compile and link application executable to start at sector 5 in flash (0x0802 0000), I get issues...
Although the .map file generated by my linker shows that application code and vectors are relocated in 0x0802 0000, when I flash and start my target with my application, the reset is done at bootloader's reset vector... What did I do wrong?

Thanks a lot in advance.

Best regards

Parents Reply Children
No data