• State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 20 subscribers
  • Views 2047 views
  • Users 0 members are here
Options
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

code execution got stuck at BL.W instruction in dissembler.

saurav sinha

Hi,

I am working on a project on stm32303vct6 based controller. When i dump my source code in controller through ST-Link debugger and run the code, it does not execute the code, i mean i didn't get the output. To verify when i run in debug mode, i can see that in dissembler my code execution got stuck at instruction "BL.W".

Below is the link of snap shot for that instant. Any one's help will be greatly appreciated.

Thanks in advance.

0