USB HID Joystick OutPut implementation

I need confirmation if I have correctly implemented an output report.
My descriptor looks like this:

   /*Endpoint*/
        0x07,                                                   /*bLength: Endpoint Descriptor size*/
        USB_ENDPOINT_DESCRIPTOR_TYPE,           /*bDescriptorType:*/
        0x81,                                                           /*bEndpointAddress: Endpoint Address (IN)   */
        0x03,                                                           /*bmAttributes: Interrupt endpoint*/
        0x40, 0x00,                                                     /*wMaxPacketSize: 64 Byte max */
        0x01,                                                           /*bInterval: Polling Interval (1 ms)*/
    /*Endpoint*/
        0x07,                                                   /*bLength: Endpoint Descriptor size*/
        USB_ENDPOINT_DESCRIPTOR_TYPE,           /*bDescriptorType:*/
        0x01,                                                           /*bEndpointAddress: Endpoint Address (OUT)   */
        0x03,                                                           /*bmAttributes: Interrupt endpoint*/
        0x40, 0x00,                                                     /*wMaxPacketSize: 64 Byte max */
        0x01,                                                           /*bInterval: Polling Interval (1 ms)*/

usb_prop.c:

  /* Initialize Endpoint 1 */
  SetEPType(ENDP1, EP_INTERRUPT);
  SetEPTxAddr(ENDP1, ENDP1_TXADDR);
  SetEPRxAddr(ENDP1, ENDP1_RXADDR);
  SetEPTxCount(ENDP1, 64);
  SetEPRxCount(ENDP1, 64);
  SetEPRxStatus(ENDP1, EP_RX_VALID);
  SetEPTxStatus(ENDP1, EP_TX_NAK);

usb_conf.h

/* EP0  */
/* rx/tx buffer base address */
#define ENDP0_RXADDR        (0x18)
#define ENDP0_TXADDR        (0x58)

/* EP1  */
/* tx buffer base address */

#define ENDP1_RXADDR        (0X104)
#define ENDP1_TXADDR        (0x100)

The device is enumerating correct.
Do I need any more changes?
Will I handle the data here?

//---------------------------------------------------------------
    case SET_REPORT:
        switch( pInformation->USBwValue1 ) // report type
        {
          case HID_FEATURE:
            CopyRoutine = CustomHID_SetReport_Feature;
            Request = SET_REPORT;
            break;
          case HID_OUTPUT:
            //CopyRoutine = ?;
            break;
        }
      break;
    default:
      break;
    }