I downloaded uVision V5.24.2.0 as developing tool for STM32F303RE. With a old version (in another pc) have no problem. The last version but as opens says that; " The Following Device Family Pack(s) are required by the project: Keil:STM32F3xx_DFP:2.1.0 " and gives two options, once I select "install" option, this message pops up "One or more Devices Family Pack Devices are not present, would you like to choose another device?"
The point is in Pack Installer, Keil:STM32F3xx_DFP version 2.1.0 (2018-1-16) is shown as installed.
Any help would be highly appreciated.
Thank you very much Kevin! So from your explanation I deduce that for the incompatible devices (chips) the last update of software must be removed and a release before pack 2.0.0 sould be used instead.
Just take advantage of your availability, one more question in this thread: is there any instruction on how to use Keil uVision in Linux? I saw some discussion but were out-dated so I wondered if you could help me on that?!
Thanks again!
Hello Hamidreza,
Have you seen this article? It might be what you need:
http://www.keil.com/support/docs/1456.htm