We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
I am trying to put the STM32F103C8 controller or Bluepill board into the debugging mode but i am only able to flash the board. Even the tutorials i found mainly are arduino base where only flashing of the hex to board is done.i am using Keil to programme and debug the device . please help me out i am struck on this from days.
More detail required!
eg, what programmer/debugger are you using?
It would be helpful to provide a link to this "Bluepill board"
Did you try the red pill :-)
I am having both ST-LINK V2(USB STICK) AND ST-LINK/V2 ISOL .currently i am flashing the board by selecting Boot 0 using stlink v2(usb stick).IDE is Keil. i even set the bits for the selection of SWD debug. link for the board that i purchased: robokits.co.in/.../stm32f103c8t6-system-board-single-chip-core-board-stm32-arm
Were you able to get a solution for this problem?