This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

uVision 5.24.2.86 drops out when trying to debug.

It seems to go through the motions, downloading etc and when it is due to reconfigure itself, it disappears.

This is a new installation on a new laptop (previous computer worked ok).

Tried un-installing and re-installing uVision and Si8051F_uVision.exe driver.

Suggestions?

Parents
  • The C2D sharing should not be an issue, it's set to an output and it does not matter if this changes during programming.

    I've tried a different SiLabs programmer and same issue. I don't have another PCB to try at present.

    I've tried using the SiLabs programming utility and I can download, run/halt, disconnect/reconnect and re-download without issues.

    There seems to me to be a uVision or uVision/driver setting issues?

Reply
  • The C2D sharing should not be an issue, it's set to an output and it does not matter if this changes during programming.

    I've tried a different SiLabs programmer and same issue. I don't have another PCB to try at present.

    I've tried using the SiLabs programming utility and I can download, run/halt, disconnect/reconnect and re-download without issues.

    There seems to me to be a uVision or uVision/driver setting issues?

Children