We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
I connected by STM32F407g-Disc1 and i checked the debug settings in the target settings in keil MDK 5. The adapter unit was being detected as STlink-v2-1 whereas it supposed to be STLink-v2-A. I ran the stlink utility and updated the firmware but nothing changed.
My PCB version is MB997D and the version of the stlink chip is STM32F103CBT6. When i connect the board it is instantiating the VCP on COM7.
What can I do to make sure I an able to communicate with the board via the virtual com port.
That part has nothing to do with Keil - you need to ask ST.