Please note: We are aware of an issue affecting replies on the Arm Community forums, which may not be loading as expected.
We apologize for any inconvenience and appreciate your patience while we investigate and work to resolve the issue.
Thank you for your understanding.
Hi everybody,
I just found this User Guide here:
www.keil.com/.../ulinkpro_ctx_debug.htm
The guide states that there would be "without Stop"-option in the debug settings. However I can't find this option. I only have "Normal", "with Pre-Reset" and "under Reset".
Is this feature not available anymore? I'm using uVision verison 5.17.
Regards, Niclas
Is the item "Without stop" dependent on the debugger I use?
I have uVision 5.23 with ST-Link/V2 and I don't have that option.
Was it removed recently?
Thanks.
Stefano