This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Using T0 pin of 8051 as output when timer0 is configured as internal timer

Can anyone tell me whether we can use the T0 pin / p3.4 pin of the AT89C55WD/8051 controller as general purpose output pin while the TIMER0 is used as internal timer?

Parents

0 Raja ChandraShekar V over 8 years ago in reply to Ar Eola

Thank U Mr.Jack for your reply. I am implementing it in my software.
Cancel
Up 0 Down

Cancel

Reply

0 Raja ChandraShekar V over 8 years ago in reply to Ar Eola

Thank U Mr.Jack for your reply. I am implementing it in my software.
Cancel
Up 0 Down

Cancel

Children

No data