We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hello, I try to use ULINK2 /ULINK ME to write my code into the internal flash of the controller. In a second step I want to debug the code using ULINK2 oder ULINK ME
I use the ULINK2 in other projects and it works as expected. In the "Cortex-M Target Driver Setup" ULINK2 detects the Device (ICODE=0x4BA00477) But when I try to "load" my program I see a message "Full chip erase in the bottom line of uVision and a blue progress bar. But finally I get an error message "Flash Timeout. Reset the target and try it again" When I configure "Erase Sectors" instead of "Erase Full chip" and start "load" I get the error message after ~3seconds, no progress bar.
I can program the compiled code via serial port using FlashMagic, then the code works as expected. Small problem with FlashMAgic: "Full chip erases" works fine, "Sector erase" does not.
Are there any known problems? Did anyone successfully program the LPC4074 using ULINK2?
Contact Keil support with this issue, this is not Keil support.