HI, I am using P89v51rd2 to control L293D. My code is running on Eval board but not on the circuit I designed (all ports are reset to High state and code is not running). I used P0.0-P0.3 for input, P2.0-P2.3 as output. only other connection is 11.0592MHz xtal with 33pF caps. Please let me know what to do Regards, FD
I don't know is it oscillating properly or not, should I check the oscillation with DSO? Is there any other way I can check oscillation?
Well that would be a start, wouldn't it? The probe will alter the characteristics of the circuit, you could also try providing an external clock source.
Don't you think that is a pretty fundamental thing to know??!
I used to have a logic probe, but I'm not sure it would help determine frequency, just that the pin was toggling.
www.ebay.com/.../141417914555
Then again I used to test 9V batteries with my tongue.
Depends on what you mean by, "DSO": en.wikipedia.org/.../DSO
If you mean Digital Storage (or Sampling) Oscilloscope then, Yes - that would do it.
In fact, any oscilloscope - it doesn't need to be Digital or Storage (or Sampling)...