Hi, Maybe this is not the right forum for this question, but is there anyone who can tell me the correct settings to compile HID-firmware for the FX2? The problem is, I've written some firmware and it works on the development board. When I download the same HEX-file to our own board, the firmware won't enumerate properly. The difference between the development board and our board is that the development board has a 128-pins FX2, our board has a 100-pins FX2. I suspect it has something to do with the 100-pins FX2 not supporting external memory, but I can't seem to find any setting that will let me compile the source right for the 100 pins. Any help is greatly appreciated, Timo
Why not try the forum at usb.org. I have had a peek there now and then and, if/when I need to do USB, I'll definitely go there. Erik
"Why not try the forum at usb.org" Last time I looked there were two - make sure you go to the developers' forum (not the consumer one)! Definitely worth a visit.