This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot execute sourcesafe commands

Is there a solution to the issue with SVCS running Sourcesafe commands?
e.g. I always get:
--- Error: can't execute '"C:\Program Files\Microsoft Visual Studio\Common\VSS\win32\Ss.exe" CP $/"xxxx" -I-'.
However, the Sourcesafe explorer always works and all the other commands use the same path.
My system is Windows XP and uVision 2.31

Parents
  • No luck I'm afraid. The basic sourcesafe explorer command (ssexp.exe) uses the same path as all the other sourcesafe commands and that works. It seems anything with a parameter associated with it fails. The output window displays the path encased in double quotes as per the article but I even tried adding additional quotes through the SVCS config dialog but it still failed.
    I can specifiy the command the same as shown in the SVCS in a command shell and that works. Maybe its specific to XP?

Reply
  • No luck I'm afraid. The basic sourcesafe explorer command (ssexp.exe) uses the same path as all the other sourcesafe commands and that works. It seems anything with a parameter associated with it fails. The output window displays the path encased in double quotes as per the article but I even tried adding additional quotes through the SVCS config dialog but it still failed.
    I can specifiy the command the same as shown in the SVCS in a command shell and that works. Maybe its specific to XP?

Children