• State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 22 subscribers
  • Views 930 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

MCB1800 Development board

sagar salunkhe

Hi,

Is it possible to program the MCB1800 development board other than using the Unlink debugger. Can we not use a parallel port to jtag interface.

Regards
Sanket