Is there a option to "STICK UART PARITY" to 1 and 0 using the CMSIS Drivers...
This is all that is defined in the HEADER file;
/*----- USART Control Codes: Mode Parameters: Parity -----*/ #define ARM_USART_PARITY_Pos 12 #define ARM_USART_PARITY_Msk (3UL << ARM_USART_PARITY_Pos) #define ARM_USART_PARITY_NONE (0UL << ARM_USART_PARITY_Pos) ///< No Parity (default) #define ARM_USART_PARITY_EVEN (1UL << ARM_USART_PARITY_Pos) ///< Even Parity #define ARM_USART_PARITY_ODD (2UL << ARM_USART_PARITY_Pos) ///< Odd Parity
Yes, using sticky parity is very valuable when needing to send 9-bit data to control device adressing.