Hi, i have a problem about how to implement the stepper steps in C or C++ programing..the question is in below...please some one help me to do this project greatly appreciated...
Project Description: Using an external potentiometer and stepper motor/driver, drive the stepper motor through speeds full-reverse through full-forward and display the current potentiometer input voltage in the Debug Viewer.
and the another i am confusing on this one... Can you use ADC1 to measure the Vbat signal on the board without additional wiring/hardware? If so, provide the code required to accomplish this. If not, provide justification.
Nothing specifically to do with Keil or ARM or STM32 - you must understand what you need to do before getting into the details of how to implement that using specific tools & devices...
homepage.cs.uiowa.edu/.../