This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Programming the P89LPC952

Hello All,

I want to know what tools are available for programming P89LPC952 through ICP?
I read EPM 900 manual it does not support LPC952 so do i need some other Board ? if so please suggest me one , and also what is flash magic and FS2 is it really necessary if i only want to program my LPC952. I don't want to use debugging .

Thanks,
Prashant

Parents

0 Westonsupermare Pier over 11 years ago

What does the vendor documentation suggest? Is there any ROM on the device that might support such operation?

http://www.keil.com/dd/chip/3936.htm
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Westonsupermare Pier over 11 years ago

What does the vendor documentation suggest? Is there any ROM on the device that might support such operation?

http://www.keil.com/dd/chip/3936.htm
Cancel
Vote up 0 Vote down

Cancel

Children

0 Prashant Singh over 11 years ago in reply to Westonsupermare Pier

Hello,

Thank you for your prompt reply.

After going through the link provided by you, I found MCB950 evaluation board which supports my device
but I am unaware of how will this evaluation board help me in programming my MCU using ICP(In Circuit Programming). Can I directly use Flashmagic utility available in keil3 for programming my MCU ?
Cancel
Vote up 0 Vote down

Cancel