This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How can I generate an input for my ADC?

I am simulating a STM32 microcontroller and I am trying to work on my code. My project is to input sound to the ADC, then process the data. But I can't find how to give a signal on my ADC (on Keil since I don't have the microcontroller on my hands yet)so I can test my code.. I am kinda lost here..

Parents

0 El Cobs over 12 years ago in reply to Westonsupermare Pier

So after trying it many times, it seems that when I run the function, there is an error along of the lines "cannot divide by zero", so the CLOCK is zero, I guess. I am not very good at Keil but on Target Options there is the Xtal 8Mhz. Should I put a timer other than that so that my function recognizes CLOCK as something other than zero?
Cancel
Vote up 0 Vote down

Cancel

Reply

0 El Cobs over 12 years ago in reply to Westonsupermare Pier

So after trying it many times, it seems that when I run the function, there is an error along of the lines "cannot divide by zero", so the CLOCK is zero, I guess. I am not very good at Keil but on Target Options there is the Xtal 8Mhz. Should I put a timer other than that so that my function recognizes CLOCK as something other than zero?
Cancel
Vote up 0 Vote down

Cancel

Children

No data