Can you use a ULINK2 for SWD on a lpc1102lvuk. This chip is a 1.8v chip. i'v set the internal jumper of the ULINK2 to the ARM position, but i get a communication falure. also in the Target/Debug/Settings/Debug of the project is can see the device has a communication error, but recignised that there is a jtag device connected Is there anything i can do to fix this or do i have to use another chip or . . . Ash
found out it was flux shorting a few pins of the conector on the underside of the ulink2 board. ulikely but cleaning the flux fixed the probem. 1 in a million i recon