This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

JUMP Problem when using RTX RTOS

Hi all ,

Using Uvision4 & LPC1768 & RTX RTOS ,
I want to jump to 0x10000 of the flash.
Before running RTX , there is no problem but after using os_sys_init(APP_TaskStart) , when trying to jump , there is a hardfault . How could I jump while RTX is running ?

By the way , Is there a way to disable RTX ?

Parents

0 ²erik malund over 13 years ago in reply to ImPer Westermark

But isn't something that have with boot loader concepts to do
Problems with the bootloader itself are just plain bad coding, problems with the hand-off can be oversights.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 ²erik malund over 13 years ago in reply to ImPer Westermark

But isn't something that have with boot loader concepts to do
Problems with the bootloader itself are just plain bad coding, problems with the hand-off can be oversights.
Cancel
Vote up 0 Vote down

Cancel

Children

No data