This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

JUMP Problem when using RTX RTOS

Hi all ,

Using Uvision4 & LPC1768 & RTX RTOS ,
I want to jump to 0x10000 of the flash.
Before running RTX , there is no problem but after using os_sys_init(APP_TaskStart) , when trying to jump , there is a hardfault . How could I jump while RTX is running ?

By the way , Is there a way to disable RTX ?

Parents

0 Gaseous Trousers over 13 years ago in reply to Tamiryan Michael

You don't know what you are doing. You write as if you know but what you write gives you away.

I am far better than you and I am not going to waste any more time with you.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Gaseous Trousers over 13 years ago in reply to Tamiryan Michael

You don't know what you are doing. You write as if you know but what you write gives you away.

I am far better than you and I am not going to waste any more time with you.
Cancel
Vote up 0 Vote down

Cancel

Children

0 ²erik malund over 13 years ago in reply to Gaseous Trousers

Bighead Posted
I am far better than you

how fitting

Erik

PS I'd like to know who 'you' is, there are many posters in this thread.
Cancel
Vote up 0 Vote down

Cancel