This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

problem with st-linkIII for keil

yu min over 13 years ago

Hello, I am using Keil uvision 4 (arm-mdk453 package) for STM32VL discovery board. I try to use ST-LINKIII to debug/download to the flash, but receive popup message "No STLink detected". But can download to flash with the st tool---"STVP". Any help will be highly appreciated.
Best Regards,

0 ²erik malund over 13 years ago

I try to use ST-LINKIII
is it in the devicelist under debug?
I do not have Keil ARM where I am right now, you must check yourself

Erik
Cancel
Vote up 0 Vote down

Cancel
0 ²erik malund over 13 years ago in reply to ²erik malund

using IAR you needed the ST dongle for ST and the IAR dongle for IAR
Cancel
Vote up 0 Vote down

Cancel