Hi all, I was using a Ulink 2 probe with JTAG link with a STM32F103 based board and all was right
Now I'm usign a STlink V2 probe with SWD link because my new board based on STM32F405 chip doesnt expose JTAG I'm stuck when I try to change the value in the watch window nothing appends and the value goes back to it's initial value ...
I'm using a registered keil µVision4 release and I ensured myself that this variable was not reset by some software stuf ...
do youhave any idea of what can I have misconfigured ???
thank's for your help
OK I've welel check and I'm using the ST-LINK/V2 not the deprecated one HW version : V2 Firmware version : V2J16S4 Port: SW thank's for your help