This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

generation of clock signal of 12MHz using LPC2368

ram charan teja puppala over 12 years ago

I am a student learning microcontrollers. now i'am working on lpc2368. i had to generate a clock signal of approximately 10MHz to 12MHz using this IC.
is it possible? if yes how is it?

Parents

0 ImPer Westermark over 12 years ago in reply to ram charan teja puppala

That depends on which chip version you have.

And NXP documentation contains that answer. Note that you may have to check the errata for the chip depending on your stepping.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 ImPer Westermark over 12 years ago in reply to ram charan teja puppala

That depends on which chip version you have.

And NXP documentation contains that answer. Note that you may have to check the errata for the chip depending on your stepping.
Cancel
Vote up 0 Vote down

Cancel

Children

No data