This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Debugging properly but not running onboard.

Hello,
I am using Uv4 for LPC2148, my LED blinking program works fine in debug mode but does not runs on the board. I am using Flash magic to flash the program.
Pls help.

Parents

0 Tamiryan Michael over 13 years ago in reply to sam san

This is the exact code which works fine without any problem

I'm missing an infinite loop here.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Tamiryan Michael over 13 years ago in reply to sam san

This is the exact code which works fine without any problem

I'm missing an infinite loop here.
Cancel
Vote up 0 Vote down

Cancel

Children

No data