This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

emIDE vs. uVision

I am looking for a tool chain for my new STM32F4 project.
I have been trying emIDE (emide.org).
It works very well with GCC.

Question: Can I use uVision with GCC as well?

Thanks,
Björn

Parents
  • It would take you a matter of minutes to verify.

    But why go to the trouble when you think you can get someone on a forum to do it for you.

    Reminds me of what my 22 year old son did recently. Him in his bedroom, me in the sitting room. The phone rings. I answer. It's him. "Dad, bring me up a cup of water".

    (I didn't)

Reply
  • It would take you a matter of minutes to verify.

    But why go to the trouble when you think you can get someone on a forum to do it for you.

    Reminds me of what my 22 year old son did recently. Him in his bedroom, me in the sitting room. The phone rings. I answer. It's him. "Dad, bring me up a cup of water".

    (I didn't)

Children