This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

how debugger like gdb works to setup a breakpoint through a jtag interface on an embedded board?

i want to know if sbdy has an idea about how once i type a command in GDB from my host to set a breakpoint on an embedded remote processor, this command will arrive to this processor through jtag and will be executed ?

thanks

0 ²erik malund over 13 years ago

i want to know if sbdy
since you believe in saving characters, I'll do the same and type 'no' instead of 'yes'
Cancel
Vote up 0 Vote down

Cancel
0 seif mngr over 13 years ago in reply to ²erik malund

off topic
Cancel
Vote up 0 Vote down

Cancel
0 ImPer Westermark over 13 years ago in reply to seif mngr

I would say that it is off-topic too, to explain exactly how JTAG functions and the actual transfer mechanisms involved.

If you are a manufacturer of chips or JTAG adapters, you have access to contact information to start a dialogue with Keil about integrating support for your specific products in the uVision system.
Cancel
Vote up 0 Vote down

Cancel