This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Hardfault exception error

Hello,

I wrote FreeRTOS code for blinking LED on STM32F103RB. When i debug the program it goes into HardFault exception. May i know what is the exact cause of this.

Parents

0 nikit biraj over 13 years ago in reply to ImPer Westermark

thank u all..
finally it worked...
have to do few changes in freertos code..
Cancel
Vote up 0 Vote down

Cancel

Reply

0 nikit biraj over 13 years ago in reply to ImPer Westermark

thank u all..
finally it worked...
have to do few changes in freertos code..
Cancel
Vote up 0 Vote down

Cancel

Children

0 Tamiryan Michael over 13 years ago in reply to nikit biraj

have to do few changes in freertos code..

Probably the wrong solution, unless it is a change to the ported code !
Cancel
Vote up 0 Vote down

Cancel
0 nikit biraj over 13 years ago in reply to Tamiryan Michael

Its not wrong..
did one change in port.c file
Cancel
Vote up 0 Vote down

Cancel